ECN Forum Forums Photo Discussion Forums Photos for General Discussion Quality Control?

[This message has been edited by Webmaster (edited 04-03-2003).]

Scott:
Can I assume that the bottom aws drilled, or did they just drill & tap for the setscrew??
Hope ya were awake when ya saw this!
Who is the mfg???
So much for the QC inspection guy!

John

The "torquer" wasn't too skilled with his handy pneumatic impact wrench.

That is indeed a high pucker factor discovery.

Come on what's the matter, just get 5/8" drill bit and....

Bjarney, I'm the torquer!! With a Snap-On torque wrench. I did the two on the left and...huh? (yes, I slash them with a sharpie)
The CØ lug is the same top and bottom.
Panelboard's C-H, and neither they nor the lug manufacturer caught it! ...S

D'oh! Apologies, electure. I completely overlooked the "extra metal" on Cø.

This question shows my lack of experience with 480/277 panelboards, but is it typical to have some type of divider/cover for the lugs? I would hate to see something fall across that....KABOOM!!!

Aw shoot.....

Well, we only needed two phases anyway..

To borrow a phase phrase from GlennH in the Crispy Critters thread:

I heard that this particular model is being phased out due to complaints...

Don't worry about CH, it's just a phase.

I can't say I'm surprised at seeing this...nothing phases me anymore.

OK, OK, I'll stop now...before this drives us all nuts

[This message has been edited by ThinkGood (edited 04-04-2003).]