ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat
Recent Posts
Safety at heights?
by gfretwell - 04/23/24 03:03 PM
Old low volt E10 sockets - supplier or alternative
by gfretwell - 04/21/24 11:20 AM
Do we need grounding?
by gfretwell - 04/06/24 08:32 PM
UL 508A SPACING
by tortuga - 03/30/24 07:39 PM
Increasing demand factors in residential
by tortuga - 03/28/24 05:57 PM
New in the Gallery:
This is a new one
This is a new one
by timmp, September 24
Few pics I found
Few pics I found
by timmp, August 15
Who's Online Now
1 members (Scott35), 536 guests, and 23 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
Page 3 of 3 1 2 3
Joined: Jun 2005
Posts: 91
G
Member
I've done it. It was cord and plug connected and plugged into a GFCI receptacle, since it was in the bathroom cabinet. It's up to the homeowner to not burn their house down doing something I would call "stupid." [Linked Image]

It looked pretty sweet when I was done, despite the fancy custom drawer being almost exactly the same height as the receptacle coverplate was wide.


-George
Joined: May 2003
Posts: 2,876
E
e57 Offline OP
Member
Surface mounted panels are ouside the wall... Surface mounted conduit too...

The line dividing here is the receptical... Otherwise it is Premises Wiring...
Quote
Premises Wiring (System). That interior and exterior wiring, including power, lighting, control, and signal circuit wiring together with all their associated hardware, fittings, and wiring devices, both permanently and temporarily installed, that extends from the service point or source of power, such as a battery, a solar photovoltaic system, or a generator, transformer, or converter windings, to the outlet(s). Such wiring does not include wiring internal to appliances, luminaires (fixtures), motors, controllers, motor control centers, and similar equipment.

And right up to the device in the drawer mounted box is a Branch Circuit. If there were a receptical at the wall, it would be utilization equipment....


Mark Heller
"Well - I oughta....." -Jackie Gleason
Joined: Feb 2002
Posts: 375
G
Member
I was referring to the picture not wiring in general.

Page 3 of 3 1 2 3

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5