ECN Forum Forums General Topics of the Trade General Discussion Area Can't Identify this Connector

I'm trying to find the other half of this connector. If you can't read the plate,it says 323-N 3P 4@ 100A 600V.

However, it sure looks like it only accepts 3 conductors plus ground. I don't know what this is and my electrical supplier has been "looking into it" for me for two days but no luck yet.

Any info appreciated.

It looks like a predecessor to arktite by crouse hinds which is a cooper company now.Looks redundant

... and is that a NEMA 1 box outside?

Arktite doesn't seem to have anything quite like it now. And the box is gasketed so I don't think it's a NEMA1...that is if the screw wasn't missing.

Start over wih the correct plug set and correct outdoor box

Isn't that arrow we see someone's trademark ...Arrow-Hart, perhaps?

Is it by any chance a Russellstoll?



_________________________________________________________________

The ultimate insult is to be replaced by a machine that does not work.............

I've a strange feeling that outlet isn't domestic... European maybe? Are there any listing agency markings on it?

I have seen a lot of Russell Stoll and they all had round pins.
Are the screws metric? If they are SAE it is probably US.

Not Continental I think, MAYBE British. No other country I know uses "AMP" rather than "A" for Ampere. Besides, 600V would be an odd rating, most stuff used for voltages up to 240/415V is only rated 500V and above the next atandard voltage is 400/690V.

What's the part the arrow is pointing towards? A screw? Or maybe the missing neutral pin?