ECN Forum Forums Code Related Discussion NEC & other Code issues Violations found when beginning a renovation?

<threadjack in progress>

I have had only one of six different inspectors NOT retighten and "check" my terminals...

Seriously, in their defense...

The NORM here is:

"My aunt Bessies' cousin's nephew knows somebody who used to work in the mines and they told me how to do it over the phone..."

Inspector's actually need to check...

Only the Lord above knows what those guys see every day. It would make us cringe. Someday I'll be an inspector too and I'll post pics...

One inspector routinely kept and used Penetrox oxygen-inhibitor on his inspections in lieu of any, rather than fail them.

Most of this ludicrosity is under the guise of kindness.

On this same service, the inspector asked me if I had mated 3-1/2" sched 80 with 3" sched 40. I proceded to explain exatly what I installed, and he pointed out that it was loose. (He had been there 1/2 hour before I got there).

It was 3" 80 sweep into the 3" 80 riser that he was speaking of, which would have been illegal with 40, let alone with different sized pipe. What had happened was that the blocks supporting the weight of the lateral pipe had shifted when the backfill was dumped in (by the GCs new dump truck, I'm sure) and the glue joint completely seperated.

He should have failed the inspection, but alas, I've never failed a service inspection.

(Joe woulda had his finger in my face and told me to do 20 push-ups!)



</threadjack>

Sorry Elec_Va... Welcome aboard!

(Well, ya did ask for horror stories...)



[This message has been edited by sparky66wv (edited 02-06-2003).]