OK, for the heck of it, I just tacked together a cube of 100K resistors (a nice round value I had a bunch of in my junkbox). Picture of the cube is being sent for posting.

Each resistor was tested before soldering, and found to be pretty close to marked value. Well within the marked 5% tolerance.

Corner to corner resistance as measured with a Fluke 8060A = 82.94 kOhms. With 1 ohm resistors, .83 ohms sounds like a good answer.

Nothing like a real-world confirmation of the theory! [Linked Image]

[Linked Image]

(edited to add image)

[This message has been edited by Webmaster (edited 09-20-2006).]