It won't work. Tie your first feed wire straight through to the 'common' on the last switch. Put the wire to the light on the common of the first switch.
The way I always explained '3-way' switching to apprentices was simple:
-Make sure there is a white neutral at the light.
-The common screw on one switch gets a hot wire, and the common on the other goes to the light.
-The 'travellers' go to each other.
[This message has been edited by Pinemarten (edited 08-23-2003).]
[This message has been edited by Pinemarten (edited 08-23-2003).]
