Matt,
Drag him over to woodshop with a wiggy... Open one of the disconnects to a 240V piece of equiptment (Lathe, drill press, etc...) Ask him why the motor works without a neutral? [Linked Image]


-Randy

PS... You should've taken one of the old "T slot" non grounding recepts to eliminate that ground hole he tried to weasle into [Linked Image]... Most of them had dual voltage ratings (10A 250V / 15A 125V)

[Linked Image from pstr-m01.ygpweb.aol.com]

[This message has been edited by Lostazhell (edited 05-30-2004).]