ECN Forum Forums General Topics of the Trade General Discussion Area Bosch tool giveaway- still waiting

Just got mine today. Made in China.

I just recieved my auger bit today. I think i sent in for it way back in April?

Kelley

Just got my drill bit a few moments ago......

Reguardless of where it was made it seems to be well machined. There is something I noticed straight off that was different about this bit as comared to others. The cutting edge is wider than the rest of the bit, and more pronounced on the leading edge. The result is a 7/8 bit that cuts at 1"? And due to the way it is cut, it would seem that it could be sharpened with a flat file more easily than a bit that would need to be sharpened from inside the flute. Theroretocialy, you could sharpen it down to a 7/8" bit over time. Now the question is how long will that take?

Someone from Bosch must post here becuase I got mine today. I agree it looks like a well made bit. Cant wait to chew up some lumber with it!

Got mine. Looks ok, wonder how it works when it hits nails

I got my bit also. It does look good.

Al

Mine arrived in the mail today.

I got the bit today also.

Thanks Bosch.

Dave

[This message has been edited by Tiger (edited 09-18-2006).]

I had given up, especially after reading that all of you got yours. I got mine today!

Got mine yesterday!

-Hal