ECN Forum Forums General Topics of the Trade General Discussion Area FPE-AFCI

Has anyone seen an AFCI available for a Federal Stab-Loc panel?

steve

Yep, located in the new panel.

Sorry, could not resist!

No... I doubt we ever will, as FPE's seem too small already. And how would you be able to keep it on with so much other arching going on....

Funny you should ask...

Check out Page 5 of this catalog http://www.schneider-electric.ca/www/ecat/documents/b_section.pdf

Common stuff in Canada. CSA approved and all. The only thing I don't know is if they are UL listed.

I will vouch from personal experience that the new line of breakers trip properly, but my understanding is that the new FPE (called Federal Pioneer up here) StabLok stuff has no association to the old Federal Pacific stuff except for identical bus/breaker style.

I have sent a link and an E-Catalogue to your email address.
Good luck


Edited to add:
oops...same link as jdadamo

[This message has been edited by bigrockk (edited 11-07-2005).]

Thanks for the link/e-mail. I'll contact Schneider and see about the listing.

steve