ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat Box
Recent Posts
NEC 2017_392.22(B)(1)(b)
_What's the smallest width

by gfretwell - 09/21/19 11:37 PM
Another weird NEC code question on Feeder Taps
by gfretwell - 09/21/19 11:35 PM
Kichler Lighting Recalls Pendant Lights
by Admin - 09/18/19 08:47 PM
Does a 'normal 3ph-AC motor' include capacitors?
by gfretwell - 09/18/19 01:20 AM
NEC Question_Cord-&-Plug EGC shorter then Neutral
by pcsailor - 09/16/19 05:26 AM
New in the Gallery:
What is this for?
Plug terminals
Who's Online Now
0 registered members (), 12 guests, and 11 spiders.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
Puck Lighting???? #51578 05/02/05 11:04 PM
Joined: May 2005
Posts: 1
H
hvac2000 Offline OP
Junior Member
I would like to install Puck 12 volt lighting but what she has is 1 transformer and 5 lights and a 3 light. She bought 5 sets. She would like 15 on the tops and 15 on the botom with 2 dimmer switches. Is there a system with 1 transformer and additional lights.? Or can I wire it with what she has? What can I do? Thanks Jay

Work Gear for Electricians and the Trades
Re: Puck Lighting???? #51579 05/03/05 04:16 PM
Joined: Feb 2003
Posts: 687
A
Active 1 Offline
Member
You did not say if they are 10 or 20w puck lights and how many watts the transformers are. I would bet the transformer in the kit is maxed out using the pucks that came with it.

You could use all those little transformers but it would need a few duplexes and makes a bit of a rats nest. Those little electronic transformers don't seem to have a long life when used frequently.

If I was forced to install puck lights with a gun to my head I would use a larger magnetic unit. Then you need to find a place for it. If you have 15 pucks on a switch and they are 20w then you would need min a 300w (each switch).

Don't forget special $$ dimmers are made for low voltage lighting.

Look back not long ago Dave was talking about these.

I would recomend not using what the customer has. I would go with under halogen under cabinet fixtures, track 12, or something similar.

Tom

Re: Puck Lighting???? #51580 05/03/05 07:51 PM
Joined: Jan 2002
Posts: 1,457
E
Electricmanscott Offline
Member
Don't do it. They are junk and will be nothing but a headache as you are probably exeperiencing right now, before you have even installed one.

Re: Puck Lighting???? #51581 05/04/05 05:23 PM
Joined: Mar 2002
Posts: 125
S
Sparks30 Offline
Member
I would stay away from the dimmer. The puck lighs I use are 20 watt. The single trans can handle 3 and the trans fits into a single gang box. Good luck.

Re: Puck Lighting???? #51582 05/04/05 05:29 PM
Joined: May 2005
Posts: 706
T
Tiger Offline
Member
IMO you can throw the pucks away now or later. Trac 12 is good, but 1" thick, so it needs custom carpentry to cover. I hear good things about 120 volt rope light for above cabinet lighting, but I'm wondering if it would work below the cabinet. It's thinner than the Track 12. Anyone try 120 volt rope under a cabinet?

Dave

Re: Puck Lighting???? #51583 05/04/05 05:43 PM
Joined: Jul 2004
Posts: 9,394
G
gfretwell Online Content
Member
I have 120v rope under my kitchen cabinets and toe kicks in the bathroom. They are plugged into a switched receptacle. One problem is the premade cordsets all have 6' cords. You will be hiding most of it or blow the U/L listing by cutting off the molded plug, installing one at the right length. From a warranty standpoint, expect to lose a segment every now and then. That "25,000 hours" must be when the last segment in the string burns out.


Greg Fretwell
Re: Puck Lighting???? #51584 05/04/05 07:49 PM
Joined: May 2005
Posts: 706
T
Tiger Offline
Member
I believe that the rating on the bulbs means that half of them die by 25,000 hours.

Dave

Re: Puck Lighting???? #51585 05/05/05 04:52 AM
Joined: Jan 2005
Posts: 40
R
rhiphi Offline
Member
The boys are right about puck lights.
I did a nice install w/ rope lights
3 glass cabnits started on the side ran the rope from the top w/ a switched outlet down the inside thru the bottom under to the next one. black taped the top so no light bleed looked very nice

also ran one in thetoe kick space of a very large island
w/ hardwood floors looked great at night

Re: Puck Lighting???? #51586 05/05/05 12:04 PM
Joined: Apr 2005
Posts: 197
L
LearJet9 Offline
Member
Puc lights are great for commercial installation. It insures many return trips for service.

Re: Puck Lighting???? #51587 05/05/05 08:51 PM
Joined: Mar 2005
Posts: 42
N
northstar Offline
Member
PUCKS SUCK.
OUR INSPECTION AGENCY WONT EVEN LIST THEM ON THE CERTIFICATES. TROUBLE, TROUBLE, TROUBLE. GO WITH LIGHT BARS, MINI CANS, OR ROAP.


Featured:

2020 National Electrical Code
2020 National Electrical
Code (NEC)

* * * * * * *

2017 Master Electrician Exam Preparation Combos
2017 NEC Electrician
Exam Prep Combos:
Master / Journeyman

 

Member Spotlight
togol
togol
NW In. USA
Posts: 421
Joined: September 2005
Show All Member Profiles 
Top Posters(30 Days)
Admin 5
Popular Topics(Views)
258,840 Are you busy
194,361 Re: Forum
183,821 Need opinion
Powered by UBB.threads™ PHP Forum Software 7.7.3