ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
Shout Box
Recent Posts
Inspections and Testing
by gfretwell. 04/20/18 08:44 PM
FEMA height and electrical equiment.,
by HotLine1. 04/20/18 08:49 AM
This anti-theist is priceless!!!
by LongRunner. 04/19/18 04:02 PM
Recall notice: Square D Services Switches
by gfretwell. 04/18/18 01:24 PM
Big Square D service switch Recall
by sparkyinak. 04/18/18 12:30 AM
New in the Gallery:
Housebilding DIY wiring
SE cable question
Who's Online Now
1 registered members (Tjia1981), 7 guests, and 7 spiders.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
240v dead front GFI #206966
09/08/12 02:53 PM
09/08/12 02:53 PM
S
Sparky77  Offline OP
Member
Joined: Nov 2008
Posts: 13
Alberta
Ok heres the situation. I'm ready to finish a house in a few weeks. The bathtub they had installed is jetted with a single 240V pump. At R/I I had done some google searching on my smart phone to see if there was at 240V dead front GFI available. I'm sure that I had found one without much trouble but wasnt smart enough to write down any of the info on it. No after all my searching I cant seem to find anything available to fit this situation. Typically I just run the tub feed into a single gang box then a switch leg out to the tub. Finish it off with a dead front GFI and its a nice clean finish. Now my only options I can come up with is:
1) 2 pole GFI breaker with a 2 pole switch in the bath room
2) 240 Volt deadfront GFI

Anyone know of anything available?

BTW the 2 pole GFI is quite costly thats why I'm looking for a more affordable solution.

Tools for Electricians:
Re: 240v dead front GFI [Re: Sparky77] #206982
09/09/12 01:18 PM
09/09/12 01:18 PM
M
mbhydro  Offline
Member
Joined: Feb 2003
Posts: 349
Winnipeg MB Canada
Is this what you are looking for?

From Leviton:

8895-00I 80A-120/240V 60Hz. Back & Side Wired Ivory
8895-00W White
8895-00E Black (Ebony)

GFCIs for Equipment Connections
SmartLock® High-Current GFCI
• Adds ground fault protection to heavy equipment: Dedicated only
for 3- and 4-wire systems that include grounded neutral
• Contact rating at GFCI: 20-125V; load capability with 125V
control relay 80A @ 240V max.
• TEST and RESET buttons confirm proper operation
• Ideal for use with spas, heater packs, high pressure washers,
industrial mixers and other equipment
• UL Recognized Component E-48380, CSA Certified LR-57811
Note: Each Cat. No. 8895 and contactor or relay combination MUST be
approved by UL. Consult your Leviton representative for a list of contactors that have been approved for use with Cat. No. 8895

Re: 240v dead front GFI [Re: mbhydro] #206983
09/09/12 04:21 PM
09/09/12 04:21 PM
S
Sparky77  Offline OP
Member
Joined: Nov 2008
Posts: 13
Alberta
Thanks. That looks like it just might work. I dont know how I overlooked that one. Only downfall is that its leviton brand and therefore has the black and red buttons on it which doesnt match the Pass and Seymour all white gfi's. I might just have to install all leviton gfi's in this job. Thanks again.


Featured:

2017 Master Electrician Exam Preparation Combos
2017 NEC Electrician
Exam Prep Combos:
Master / Journeyman

 

Member Spotlight
noderaser
noderaser
Portland, Oregon, United States
Posts: 404
Joined: March 2007
Show All Member Profiles 
Top Posters(30 Days)
Popular Topics(Views)
245,868 Are you busy
182,918 Re: Forum
172,743 Need opinion
Powered by UBB.threads™ PHP Forum Software 7.6.1
(Release build 20180101)
Page Time: 0.026s Queries: 15 (0.005s) Memory: 0.9510 MB (Peak: 1.0752 MB) Zlib enabled. Server Time: 2018-04-22 06:37:03 UTC