Mark, Thanks.
I might have considered taking it over or under inside the trany to the back and out, but then again, that is a lot of wire to reach back there for....
I wanted to do just that.
![[Linked Image]](https://www.electrical-contractor.net/ubb/smile.gif)
It would have been much 'cleaner'.
The problem is the coils literally touch the sides and the rear, there is no place I can enter on the rear sides. It is also very tight between the cement pad and the frame holding the coils.
I hear you on the trough, it's 12" x 12" with 16 - 600s and 4 - 4/0s. But I am not worried we measured like we where running pipe and used a hydraulic cable bender to shape the conductors to fit. There is almost no contact between the conductors and trough.
The conductors are resting on the 4" bushings of the flex and the RNC I used to line the holes into the transformer.
I have not been back to the job for a while, it still looks like it does in the pictures.
Bob
