ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat Box
Recent Posts
Ground fault remover :-)
by gfretwell - 03/29/20 12:26 AM
Pole climbing in Norway
by Trumpy - 03/28/20 11:43 PM
Where is Everyone?
by Trumpy - 03/28/20 10:46 PM
Do you count seconds?
by HotLine1 - 03/26/20 11:36 AM
Mourning the death of this forum!
by HotLine1 - 03/25/20 06:45 PM
New in the Gallery:
Facebook follies, bad wiring
FPE in Germany pt.2
Who's Online Now
0 registered members (), 15 guests, and 9 spiders.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
Page 2 of 2 1 2
Re: Smoke Detectors [Re: leland] #174966 02/18/08 05:01 PM
Joined: Jun 2003
Posts: 1,143
D
DougW Offline
Member
Had an odd problem like this at the FD once (then later at my own house).

The 2nd floor smokes were fed by a conduit run that enetered the attic space and went above the insulation. It then re-entered the living area.

Seems the airflow was just enough to allow condensation to form and trickle into the back of the detector, causing them to sound for no reason. Removing the detector from the circuit (of course) enabled the other to function, and revealed evidence that it had been happening for a while (rust traces).

I've since heard of EC's using a dab of firecaulk or a shot of spray foam in the pipe entrance to prevent this occurrence.

Work Gear for Electricians and the Trades
Re: Smoke Detectors [Re: DougW] #174969 02/18/08 06:29 PM
Joined: Jul 2007
Posts: 1,335
S
sparkyinak Offline
Member
Sounds like a band-aid fix for a bigger problem


"Live Awesome!" - Kevin Carosa
Re: Smoke Detectors [Re: sparkyinak] #175060 02/21/08 02:36 PM
Joined: Feb 2003
Posts: 687
A
Active 1 Offline
Member
Ya that is sometimes a problem. You would think if all the pipe runs end in a heated space and you keep the pipes at the joist level it would not happen, but it does. Used duct seal on the pipes. Also moved insulation over the EMT in the atic. Realy I think is is more of an insulation in the atic issue in most cases. Have herd the ideal solution is to have the pipes go in the side of the box not the top. Maybe that would work if you could keep the pipe at the bottom of the joist deep in the insulation. Some smokes have a gasket to prevent airflow. But it still happens. Maybe a bit of fiberglass insulation in the J-bx.

The worst is when there was a problem but have no idea which one of the 10 or so devices caused it. I wish the SD would have a resetable indicator to show if that perticular one was triped.

Just herd today FireX recall on CO detectors.

Re: Smoke Detectors [Re: Active 1] #175061 02/21/08 02:44 PM
Joined: Feb 2003
Posts: 687
A
Active 1 Offline
Member
Do like me. Have the smoke hang by the wires. Then if it goes off hit it like a piƱata.

Page 2 of 2 1 2

Featured:

2020 National Electrical Code
2020 National Electrical
Code (NEC)

* * * * * * *

2017 Master Electrician Exam Preparation Combos
2017 NEC Electrician
Exam Prep Combos:
Master / Journeyman

 

Member Spotlight
The_Lightman
The_Lightman
Orlando, Fl, USA
Posts: 49
Joined: August 2001
Show All Member Profiles 
Top Posters(30 Days)
Admin 8
Trumpy 5
Popular Topics(Views)
264,295 Are you busy
199,239 Re: Forum
188,118 Need opinion
Powered by UBB.threads™ PHP Forum Software 7.7.3