I remember one of the guys I worked with way back using the rear dual wheels of the truck to bend offsets in 2" EMT!
I get funny looks from people when they see me with a stick of 2" EMT wedged between the rear tire and the ground and start prying. It's a great way to take the bend out of an over-bent angles. If there's a JLG on the job the knobby tread is great to seat the bend on. Next time I run 2" I think I'll throw a stick of 3" GRC in the conduit rack. That way if I run into an over-bend problem I can just stick the EMT inside the pipe and take some bend out. Can't do too much though because of deformation..
