It's an old motor I had laying around that was pulled from a machine that was scrapped. I think it from a bell and howell inserting machine. I want to install it on a hay lifter for a friend but I need it be 120 volt and I don't know if the direction is correct.
The complete specs of the plate are
spec 35e412-72
frame 56
ser 376
h.p. 1/2
volts 115/230
amps 8.6/4.3
rpm 1725
hz 60 ph 1 class A
ser f. 1.25 DES N code L
rating 40°C AMB F
Baldor Electric Co.
Fort Smith ARK
It has a capacitor and a start switch. I suppose I could pull it apart and see what windings the wires go to. I found some very nice drawings in the tech ref secton that I could refer to and get it going.
[This message has been edited by jdevlin (edited 07-13-2004).]
