ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
Shout Box
Recent Posts
Air Compressor feeder conductor sizing
by Potseal. 01/15/18 09:08 PM
VDE 0100 to introduce AFCIs
by LongRunner. 01/15/18 11:38 AM
Under carpet cable?
by HotLine1. 01/15/18 09:57 AM
Any New Years Resolutions?
by Bill Addiss. 01/13/18 10:21 AM
New in the Gallery:
Housebilding DIY wiring
SE cable question
Who's Online Now
0 registered members (), 21 guests, and 7 spiders.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
Dedicated Equipment Space #76039
11/03/00 11:29 AM
11/03/00 11:29 AM
J
James Morier  Offline OP
Junior Member
Joined: Nov 2000
Posts: 1
Albany, NY
I have a new installation where the MC ran hot water heat pipes less than 2 inches away from the side of an electrical panel. The heating line contains an automatic air bleeder valve near the top of the panel. The lines do not enter the dedicated equipment space as defined in 110-26.f. The outlet of the bleeder valve points away from the panel and under normal operation, should not cause a water problem. I can not find anything in the code that prohibits this installation. I would like to have the MC move his lines, but I need back-up from the code. Am I missing something?

2017 / 2014 NEC & Related Books and Study Guides
Re: Dedicated Equipment Space #76040
12/04/00 11:41 AM
12/04/00 11:41 AM
C
cinkerf  Offline
Member
Joined: Dec 2000
Posts: 84
Pittsburgh, Pennsysvania. ...
Quote
Originally posted by James Morier:
I have a new installation where the MC ran hot water heat pipes less than 2 inches away from the side of an electrical panel. The heating line contains an automatic air bleeder valve near the top of the panel. The lines do not enter the dedicated equipment space as defined in 110-26.f. The outlet of the bleeder valve points away from the panel and under normal operation, should not cause a water problem. I can not find anything in the code that prohibits this installation. I would like to have the MC move his lines, but I need back-up from the code. Am I missing something?

Depending upon the width of your panelboard you may be able to use 110.26(a)(2)


Featured:

2017 Master Electrician Exam Preparation Combos
2017 NEC Electrician
Exam Prep Combos:
Master / Journeyman

 

Member Spotlight
Scott35
Scott35
Anaheim, CA. USA
Posts: 2,708
Joined: October 2000
Show All Member Profiles 
Top Posters(30 Days)
sparky 21
Admin 19
Potseal 13
Popular Topics(Views)
243,514 Are you busy
180,311 Re: Forum
170,804 Need opinion
Powered by UBB.threads™ PHP Forum Software 7.6.1
(Release build 20180101)
Page Time: 0.013s Queries: 14 (0.003s) Memory: 0.9416 MB (Peak: 1.0585 MB) Zlib enabled. Server Time: 2018-01-16 23:31:42 UTC