Installation in a hotel expansion - 06/09/05 04:09 PM
Re: Installation in a hotel expansion - 08/03/05 07:08 AM
![[Linked Image from images.industryclick.com]](http://images.industryclick.com/files/31/506wwh08full.jpg)
Re: Installation in a hotel expansion - 08/03/05 01:00 PM
So, this installation is fine as installed but as soon as the rock is placed it violates 386.10.4 and 386.12.5?
Re: Installation in a hotel expansion - 08/03/05 03:53 PM
Are you allowed to bend that flat track raceway, or do you have to use a fitting?
Re: Installation in a hotel expansion - 08/04/05 12:16 AM
That "flat track raceway" is called Wirewmold; and yes, you are allowed to bend it:
http://www.wiremold.com/www/commercial/tech_support/faq/faq_detail.asp?faq_id=37
...and you can buy one for $69.90 here: http://www.electricsupplyonline.com/prod/wiremold/600b_w003980.php
OR...
you could carefully use a 1/2" EMT bender - BUT, as EMT is round and wiremold is square your results may vary and the wiremold will more than likely show the tell-tale marks of an EMT bender having been used.
[This message has been edited by Celtic (edited 08-03-2005).]
Quote
Question:
Is a bender available for the 500 and 700 series raceways?
Answer:
The 600B Bender is used to make bends, saddles and offsets in the 500 and 700 series raceways.
Is a bender available for the 500 and 700 series raceways?
Answer:
The 600B Bender is used to make bends, saddles and offsets in the 500 and 700 series raceways.
...and you can buy one for $69.90 here: http:/
OR...
you could carefully use a 1/2" EMT bender - BUT, as EMT is round and wiremold is square your results may vary and the wiremold will more than likely show the tell-tale marks of an EMT bender having been used.
[This message has been edited by Celtic (edited 08-03-2005).]