Just wondering if anyone has any experiences to pass on regarding pro and cons of different types of 15KV cable and/or terminations.

I have to spec and install some. Customer spec is long but actually very generic. 133% shield is required. Cu conductor. EPR and CCLP insulation are mentioned. Overall jackets listed are chlorosulphonated polyethylene, neoprene or polyvinyl chloride.

A PE is involved but I have some input....

Feeders will be underground in conduit through manholes. Terminating in transformers/switches above ground.

Anyone?

We generally use 3M products, they seem to be the norm in my area.

http://tinyurl.com/b3zmn
3M™ Terminations

[This message has been edited by Celtic (edited 12-12-2005).]
Link was almost 200 characters long!

[This message has been edited by Celtic (edited 12-12-2005).]

I prefer the 3M, but a lot of guys I work with prefer the Raychem. Ultimately I don't think it makes enough difference to argue about.

I personally prefer the Raychem stuff.
But as George mentioned above, there's very little difference.