Hi,
Is there any good place on the internet to get a refresher course on AB PLC'S? I know there are boat loads of books available.

Which are the best?

Thanks for any responses.

Regards

Greg

If you want generic info, search for PLC tutorial. If you want specific, you will need to visit www.software.rockwell.com, or just search for Rockwell Automation. Be prepared to spend $$ for this training.

Rick Miell

If you can get your distributer to set you up with AB they run a great 2 day course and it is usually free.

Charlie

Check out the following link, there is a 15 day free trail on a Allen Bradley RSLogix Simulator
Good luck http://www.thelearningpit.com/

I highly recommend the RSLogix simulator program. I bought it when the 15 day trial expired, it's only $30. Definitely worth it, in my opinion.

plcs.net has a lot of good resources, as well as a very good discussion forum.

After replying to that thread about conduit bending videos, I thought I'd recommend all 3 books by Richard Cox. They are very thorough and informative, they are available to purchase online via his site, and his service is excellent. He has books on conduit bending, motor control, and PLCs.

Coxco.net

OK, I goofed there, this was supposed to be new thread....