ECN Forum
Posted By: itannicnic Installation requirements? - 06/22/01 06:24 PM
I'm new to code. Are there any special regulations regarding the installation of one of these systems? I notice they pull up to 4 amps, which seems pretty hot.
http://www.research.compaq.com/wrl/techreports/html/TN-13/
Posted By: Anonymous Re: Installation requirements? - 06/22/01 07:17 PM
I like this topic much better than the 180° topic! Hahahaha!
Posted By: Bill Addiss Re: Installation requirements? - 06/22/01 10:37 PM
But can We get a pickle to last 100 years?

[Linked Image]
Bill
Posted By: Tom Re: Installation requirements? - 06/22/01 10:44 PM
That was interesting. Probably needs to be addressed by the FDA. How did you ever stumble across this site?

Tom
Posted By: Scott35 Re: Installation requirements? - 06/23/01 06:22 AM
Now that was an excellent link!!! Had to print that entire page's data, just because of the trivial value in future.

Just goes to show how science uses logic to determine an end result. Multiple test subjects [Bok Choy, Mandarin Orange, then 3 different types of pickles].
Never even thought about drawing a Plasma across a pickle before, but I guarantee every pickle seen now is going to have a different "Value" - 1st will be pondering it's electroluminescence, 2nd would be it's taste!!! [Linked Image]

Scott SET
© ECN Electrical Forums