ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat
Recent Posts
90.5(C) Explanatory Material 2023
by renosteinke - 07/14/24 02:48 PM
Hello... again!
by renosteinke - 07/14/24 02:14 PM
2023 CEU Course
by renosteinke - 07/12/24 03:26 PM
Counterfeit Code Books?
by Comprehensiveedu - 07/12/24 12:16 PM
Old low volt E10 sockets - supplier or alternative
by gfretwell - 07/11/24 08:51 PM
New in the Gallery:
This is a new one
This is a new one
by timmp, September 24
Few pics I found
Few pics I found
by timmp, August 15
Who's Online Now
0 members (), 538 guests, and 13 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
#30752 10/27/03 10:29 AM
Joined: Jan 2003
Posts: 3
F
Junior Member
Can someone tell in laymen terms what a tap conductor is.

Thank you

#30753 10/27/03 12:09 PM
Joined: Nov 2000
Posts: 2,148
R
Member
Fred,
Quote
Tap Conductors. As used in this article, a tap conductor is defined as a conductor, other than a service conductor, that has overcurrent protection ahead of its point of supply that exceeds the value permitted for similar conductors that are protected as described elsewhere in 240.4.
In general a tap conductor is a conductor where the line side overcurrent protective device exceeds the ampacity of the conductor. However there are other sections of the NEC that do permit oversized overcurrent protective devices to be used on conductors that are not tap conductors. The most common example is a motor circuit conductor.
Don


Don(resqcapt19)

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5