ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat
Recent Posts
Square D "All-In-One" Panelboard
by NORCAL - 11/30/21 12:48 PM
Where is Everyone?
by luckyshadow - 11/21/21 10:14 AM
It's been an interesting career
by The Watt Doctor - 11/19/21 09:56 AM
Well I am back to stay (nearly 6 years)
by The Watt Doctor - 11/19/21 09:17 AM
Motor Load Relationships Between Fans and Pumps
by The Watt Doctor - 11/18/21 09:24 AM
New in the Gallery:
240/208 to a house
240/208 to a house
by wa2ise, October 9
Now you know.
Now you know.
by Tom_Horne, September 7
Who's Online Now
0 members (), 58 guests, and 22 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
#207019 09/14/12 06:44 PM
Joined: Sep 2012
Posts: 1
N
niki Offline OP
New Member
Hello. I hope that this is the right place for this, but I need some help with a 3 phase motor. I am a glass artist, and have a polishing lathe that is a 5 hp, 3 phase motor turning a spindle on bearings. I have several issues. First, I do not have three phase at my home studio, so got a rotary phase converter. It runs two pieces of equipment for me. After running the lathe for 30 minutes, the shaft at the bearings heats up an awful lot. My infrared only says 130 but it feels hotter than that. It is well greased. When it is not running the voltage is as follows:

a-b 221
a-c 224
b-c 241

on running:

a-b 209
a-c 215
b-c 221

Is that alright, and what should I do if anything about the shaft heat?

Second to that, is there anyway to add speed control to this without reworking the pulleys? The belt is around the shaft, and encased in a cabinet, so I don't know how to adapt that.

Thanks

Dick in San Diego

Joined: Apr 2002
Posts: 7,283
Likes: 3
Member
Niki:
The advice I will give you is to consult a local licensed electrical contractor to check your installation.

The forums are not intended to provide 'how to' guidance to DIY people.

This thread is being locked.


John

Link Copied to Clipboard
Featured:

Tools for Electricians
Tools for Electricians
 

* * * * * * *

2020 Master Electrician Exam Preparation Combos
2020 NEC Electrician
Exam Prep Combos:
Master / Journeyman

 

Member Spotlight
electure
electure
Fullerton, CA USA
Posts: 4,288
Joined: December 2000
Top Posters(30 Days)
Admin 3
dsk 2
Popular Topics(Views)
286,302 Are you busy
218,753 Re: Forum
204,906 Need opinion
Powered by UBB.threads™ PHP Forum Software 7.7.5