ECN Forum Forums General Topics of the Trade General Discussion Area Tape measures

Bjarney,
The owner of a company I worked for would hardly use anything but a wooden rule.Being limited to 6 foot looked like a pain in the a** to me.I never used one.I figgered it was a northern thang(he was from Long Island)

yes Bjarney,
I have worked with 'salts', who had educated me to the evils of metal rules.

However even wood is not completely dielectric......so comes the false sense of security.....

Fat Max here. Stanley tape measures have always been the best to me. To me the worst thing is finding a way to keep them on your belt. They always fall off.

Regards,
Doc

Bjarney,

Although I don't bend conduit nearly as much now that I work as a maintenance electrician as I use to when I worked construction, I prefer to use a wooden folder for bending conduit. They're very handy for finding center on the bends. I also use a 25' Fat Max. Matt

I'm currently using Stanley tapes -- Had to have my current 15' one shipped from Arizona so I could have one which read in inches across the whole width (it's practically impossible to buy tapes without metric graduations on in this country now).

I still have an old folding wooden rule (1 yard) which I find handy in some situations.

Had a funny tape measure story today, plumbing company owner comes on site and starts going off on his guys about proper heights. Says to his guys "Half you guys can't read a tape measure and the other half don't even own one." Our owners first question to every green horn looking for a job is "Can you read a tape measure?" Its funny how many guys have never been near one.

Stanley Max Steel.

I'm getting the new Klein with the magnets next...

One week while at a factory, I went through three tapes from dropping them at various heights when trying to place it in my belt pocket...

Later, I learned that if I removed the belt clip, it was less likely to get hung and feel falsely "secure" on the belt pocket. Hadn't dropped one since!

I have always thought of my Klein tape as my chevy.. costs a little more but takes alot more.

I like using a Wooden Foldable Rule for things like marking the mounting height for Receptacles and Switches
(like a Story Pole),
along with Conduit work
(measurements to a given spot for bends, depth of saddles, also when making multiple similar saddles, offsets or 90's).

Had a really bitchen one which sprouted legs and ran off around 1998. Brought it out rarely to avoid the "Run-Away" situation as long as possible!
Had it from 1982 to 1998 - making it the longest period of time I held onto a Measuring Device before it was broken or disappeared / MIA. <Yeah, Baby!!!>

I have several measures now, ranging from a 16' "thin blade" Klein, to a 100' "roll" tape.
I use a bright orange " 'El Cheap-O " 25' "fat blade" tape on the job, which so far has not vanished!

Have to deal with not just people in the field taking off with tools, but my Father tends to grab tools, then toss them into his Van when finished. They end up inside one of the many "Potpourri" boxes, so instead of searching aimlessly for days, I just go buy a new tool.

BTW, where can I find another kick a** Wooden Folding Measure? Something about 15' long with 1" minimum width.

Scott s.e.t.

Craftsman 25' yellow w/ black rubber. Sturdy, locks down tight, when it goes bad, return it to Sears no questions asked.