ECN Forum Forums Photo Discussion Forums Photos for General Discussion No Straps

Beam Clamps rigged with "Minis" would've been easy to use here.
How did the rest of the installation look ?

What kind of facility is that? Are those little cables cross-ties that are connected to the eyebolts on the beams? Seems like a lightweight building frame?

Same guy probably left that j-box open above the feeder and didn't secure the mc cables either.

It looks as though the gas line to the overhead heater is supporting the feeder.

Can anyone tell me if there is a violation in having that pullbox located so close to the back of that heater?

In any event, it doesn't seem like such a good location for it, IMHO...

Mike (mamills)

The rest of the installation was fair. I know the person who did this and I busted his balls big time. He always does things to fast and in a damn hurry.
As far as the heater, I really dont think the back of this heater will ommit that much heat.
This is an old American Appliance buliding, which as you know went bankrupt, the new owner is spitting up into three units, each with there own service.