ECN Forum Forums Code Related Discussion NEC & other Code issues GF BREAKER or STANDARD?

Hi,
I need to set a 60A load center out at a pool for the pumps/heat etc..

Is it best to feed this whole panel from a gf breaker or just use individual breakers where required? All of this equipment has to be fed from a GF breaker anyway does it not? Outlets can get a GFI recept but the pump is 240 V and the heat is 120 V.

Thanks for any replies.

-regards

Mustang

[This message has been edited by mustangelectric (edited 10-28-2004).]