Many mobiles here seem not to be certified for electrical even though some were build here in BC.
Is there anywhere i can find a list of what needs to be done for them to get certified by the BCSA.
these are the things in know so far
bond waterpipe &gas pipe if there is one
bond frame
bond skin
range and dryer not to be hardwired
gfci for outside, heat tape and baths
panels not to be in cloths closets
all electrical equipment to be working IE exhaust fans ,switches and receptacles also to be in good working condition.
hallway switch for furnace.
Insulation test and written record of test results on all branch circuits.
Anyhow does anybody have a check list for all of this they would like to share.
I have found quite a lot of info in section 70 for factory built but it would be nice to have all the info on a sheet.
I wish this was on the BCSA site but its not.
Last edited by dougwells; 02/13/08 02:49 PM.