The Electrical Contractor Network

ECN Electrical Forum
Discussion Forums for Electricians, Inspectors and Related Professionals

Books, Tools and Test Equipment for Electrical and Construction Trades

Register Now!

Register Now!

We want your input!

Featured:
   

2017 NEC and Related
2017 NEC
Now Available!

   
Recent Posts
Sprinklered equipment 26-008
by bigpapa
12/02/16 04:24 PM
On Delay Relay with Auto Reset
by Potseal
12/01/16 09:59 AM
Wow, that was close!
by jraef
11/28/16 07:06 PM
Earthquake in New Zeeland
by RODALCO
11/27/16 11:25 PM
Calling all Non-US members!! (Non-US only)
by Tjia1981
11/27/16 06:33 AM
New in the Gallery:
12.5A through 0.75mm flex (just out of curiosity)
Shout Box

Top Posters (30 Days)
gfretwell 13
HotLine1 9
Trumpy 8
Texas_Ranger 8
sparkyinak 7
Who's Online
0 registered (), 255 Guests and 4 Spiders online.
Key: Admin, Global Mod, Mod
Topic Options
Rate This Topic
#99306 - 04/08/05 07:59 AM 2005 changes list?
Yoopersup Offline
Member

Registered: 03/04/03
Posts: 826
Loc: Michigan
Where could one find a list of most if not all of the 2005 N.E.C. Code revisions???

Top
2014 / 2011 NEC & Related Books and Study Guides
#99307 - 04/08/05 08:19 AM Re: 2005 changes list?
gfretwell Offline

Member

Registered: 07/20/04
Posts: 9045
Loc: Estero,Fl,usa
National Electrical Code®, Electronic Edition
2005 Edition.
What's New in this Edition?
I. Format Changes:
• New headings at top of each two-page spread (PDF version) identify first and last Code section on the pages, to help in locating sections.
• Bullets in margin used to indicate where paragraphs have been deleted between the 2002 and 2005 editions
II. New Articles:
• Article 353 - High Density Polyethylene Conduit: Type HDPE Conduit
• Article 409 - Industrial Control Panels
• Article 506 - Zone 20, 21, and 22 Locations for Combustible Dusts, Fibers, and Flyings
• Article 682 - Natural and Artificially Made Bodies of Water
III. Article Relocation:
• Article 80 - Administration and Enforcement relocated as Annex G
• Article 527 - Temporary Installations relocated to Article 590
IV. Significant Technical Changes:
• Chapter 1:
o New Definitions for
§ System Bonding Jumper
§ Grounding Electrode
§ Handhole Enclosure
§ Supplementary Overcurrent Device
o Revised requirement for number of entrances/exits to working spaces containing large electrical equipment
• Chapter 2:
o New requirements for identification of ungrounded branch circuit conductors
o Revised requirement for disconnecting ungrounded conductors of multiwire branch circuits
o New GFCI requirements for dwelling unit laundry and utility sinks, for outdoor receptacles installed at occupancies other than dwelling units, and for boat hoists
o Revised AFCI requirement
o New requirement for identification of ungrounded feeder conductors
o Reorganization of Article 220
o New requirement covering engineered series rated systems in existing occupancies
o Revised requirements concerning the use of system bonding jumpers
o New requirements covering the use of concrete-encased grounding electrodes
• Chapter 3
o Revised requirements on protection against corrosion and deterioration of electrical equipment
o New requirements on the use of unshielded insulated conductors in systems operating over 2000 volts
o New requirements on the installation of handhole enclosures
o Relocation of conduit bending radius table from Article 344 to Chapter 9, Table 2
o Revised requirements on the installation of cable assemblies in raceways
o New requirement on the use of power distribution blocks in metal wireways
• Chapter 4
o New requirement on the installation of flexible cord in raceways in industrial establishments
o New provision for use of GFCI protection where equipment grounding means is not available in switch enclosure
o Revised requirement on the protection of receptacles installed in wet locations
o New provision for the use of GFCI protection for luminaires where equipment grounding conductor is not available at outlet
o New GFCI requirement for cord-and-plug-connected vending machines
o New Article 430, Part X, on Adjustable-Speed Drive Systems
o New requirement for short-circuit current rating marking of air-conditioning equipment controller or control panel
• Chapter 5
o New provision to use non-explosionproof seals in Class I, Division 2 locations
o Revised requirement on hazardous (classified) locations in commercial garages
o Revised requirement on sealing of conduit installed underground below the classified locations at a motor-fuel dispensing facility
o New requirement covering the number of recreational vehicle sites that are required to have 50-ampere receptacles
o New requirement on motor fuel dispensing at marinas and boatyards
o New requirement for listing of decorative (holiday) lighting equipment
• Chapter 6
o New definition for section sign and new requirement for field-installed secondary wiring of section signs.
o Revised requirements on insulation of equipment grounding conductor for swimming pool pump motors
o New requirement on accessibility of wet-niche luminaires
o Revised swimming pool bonding requirements with new rules on installing an alternate means for bonding at pools
o New definition of Building Integrated Photovoltaics
o New requirements on the installation of ungrounded photovoltaic power systems
o New rules on PV systems using utility-interactive inverters
o New requirement on location of disconnecting means in a fire pump supply circuit
• Chapter 7
o New provision permitting fuel cells as source of power for emergency and legally required standby systems
o New requirement for selective coordination of emergency and legally required standby overcurrent protective devices
o New permission to use non-power-limited wiring methods and power-limited wiring methods in the same fire alarm circuit
o New provisions for the use of circuit integrity (CI) cables in fire alarm systems
o Revised requirement on the mechanical execution of work for optical fiber cables and raceways
• Chapter 8
o New definition of communications equipment
o New requirements on mechanical execution of work for communications circuits, CATV systems, and network-powered broadband communications systems
o New provisions for the use of circuit integrity (CI) cable in communications systems
o New requirements covering the use of CATV raceways
o New cable types and permitted substitutions of network-powered broadband communications systems
• Chapter 9
o Relocation of conduit and tubing bending radius table from Article 344 to Chapter 9, Table 2
• Annexes
o New Example D3(a) on Industrial Feeders in a Common Raceway
o Revised Annex E with additional information on building construction types for use with application of Article 334
_________________________
Greg Fretwell

Top
#99308 - 04/08/05 08:40 AM Re: 2005 changes list?
Yoopersup Offline
Member

Registered: 03/04/03
Posts: 826
Loc: Michigan
THANK YOU!

Top



ECN Electrical Forums - sponsored by Electrical Contractor Network - Electrical and Code Related Discussion for Electrical Contractors, Electricians, Inspectors, Instructors, Engineers and other related Professionals