The Electrical Contractor Network

ECN Electrical Forum
Discussion Forums for Electricians, Inspectors and Related Professionals

Books, Tools and Test Equipment for Electrical and Construction Trades

Register Now!

Register Now!

We want your input!

Featured:
   

2017 NEC and Related
2017 NEC
Now Available!

   
Recent Posts
Industrail Control Panel bonding per 409.108
by sparkyinak
Yesterday at 03:17 PM
Calling all Non-US members!! (Non-US only)
by aussie240
12/07/16 02:39 AM
Photo Upload Tutorial
by DanK
12/06/16 11:35 PM
Sprinklered equipment 26-008
by bigpapa
12/02/16 04:24 PM
On Delay Relay with Auto Reset
by Potseal
12/01/16 09:59 AM
New in the Gallery:
12.5A through 0.75mm˛ flex (just out of curiosity)
Shout Box

Top Posters (30 Days)
gfretwell 13
HotLine1 9
Texas_Ranger 8
sparkyinak 8
Trumpy 6
Who's Online
0 registered (), 202 Guests and 6 Spiders online.
Key: Admin, Global Mod, Mod
Topic Options
Rate This Topic
#87910 - 04/29/04 07:10 PM concentric knockouts
jmcelectric Offline
Member

Registered: 01/20/04
Posts: 16
i can`t find any code article on concentric ko`s that says i need a bonding bushing,other than service equipment.do i need a bonding bushing with a feeder to a panel if the conduit is being used as the equipment grounding conductor?what if i have a seperate ground wire ?any help would be appreciated.

Top
2014 / 2011 NEC & Related Books and Study Guides
#87911 - 04/29/04 07:11 PM Re: concentric knockouts
Ryan_J Offline
Moderator

Registered: 08/19/03
Posts: 1355
Loc: West Jordan, Utah, USA
250.97


I'm sorry JMelectric. I should have at least said welcome to the forum. My bad.

Anyway, welcome to the forum. Take a look at 250.97 which addresses over 250V systems very clearly, then see 250.96 which addresses under 250V systems very not so clearly

[This message has been edited by Ryan_J (edited 04-29-2004).]
_________________________
Ryan Jackson,
Salt Lake City

Top
#87912 - 04/29/04 07:38 PM Re: concentric knockouts
jmcelectric Offline
Member

Registered: 01/20/04
Posts: 16
a little gray but after reading it a few times it makes sense ..thanks

Top



ECN Electrical Forums - sponsored by Electrical Contractor Network - Electrical and Code Related Discussion for Electrical Contractors, Electricians, Inspectors, Instructors, Engineers and other related Professionals