ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals

Topic Options
Rate This Topic
#213308 - 04/06/14 07:02 PM R123 refrigerant alarm
frank Offline
Member
Registered: 05/29/01
Posts: 374
Loc: windsor ontario canada
I'm installing a refrigerant alarm in a 3000 ton chiller plant.I want to run 1\2 or 3\4 EMT along the I beams in the ceiling and come down next to the chillers with a 90 and along the front mounted on uni strut to the detectors which will be located below the chiller control panels at 18" on center.
Normally I would use ridged on anything mounted like this but the circuits are extra low voltage and my fear is that should the pipe be hit with a lift instead of folding like EMT Ridged will pull from the floor mounted struts and rip the detectors apart or damage the chiller control panel.The old alarm is currently piped in 1/2 EMT and ran through the panel to the detector.Looking for code rules and opinions.Thanks
Top
Tools for Electricians:

Member Spotlight
Member Since: 01/22/05
Posts: 5316
New in the Gallery:
SE cable question
Featured:

2017 NEC and Related
2017 NEC
Now Available!

Shout Box


Who's Online
0 registered (), 51 Guests and 10 Spiders online.
Key: Admin, Global Mod, Mod
 
New in the Gallery:
SE cable question
 
Top Posters (30 Days)
Admin 47
HotLine1 43
gfretwell 19
Ruben Rocha 12
Trumpy 9
 
Newest Members
Scotto, Freecrowder, clee512, Jdscott2005, FAIZAN

ECN Electrical Forums - sponsored by Electrical Contractor Network - Electrical and Code Related Discussion for Electrical Contractors, Electricians, Inspectors, Instructors, Engineers and other related Professionals