ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals

Topic Options
Rate This Topic
#148714 - 09/26/02 10:32 AM Voltage Boost Transformer Schematics - 1 Phase
Scott35 Offline

Broom Pusher and
Member
Registered: 10/19/00
Posts: 2707
Loc: Anaheim, CA. USA
This post contains Voltage Boosting Transformer Connections for Single Phase 2 wire applications.

Transformers are normal Isolated Power Transformers with Split Primary and Secondary coils.

To make these Transformers "Voltage Bucking" ( Voltage Reducing), simply swap Input and Output connections.

Schematics set #1; 120 VAC in, 132 VAC out 1 phase 2 wire:


Pictorial Diagram


1 Line Diagram

Schematics set #2; 240 VAC in, 264 VAC out 1 phase 2 wire:


Pictorial Diagram


1 Line Diagram

FYI - Any combination of Input and output voltages may be derived from these setups by applying the basic connections per windings shown here.
Examples:
Primaries set for 120 VAC, Secondaries set for 24 VAC - 120 VAC in, 144 VAC out,
Primaries set for 240 VAC, Secondaries set for 12 VAC - 240 VAC in, 252 VAC out.
_________________________
Scott " 35 " Thompson
Just Say NO To Green Eggs And Ham!
Top
Test Equipment:
Large Selection of Test Equipment For Electrical, HVAC, Test & Measurement
Large Selection of Test Equipment For Electrical, HVAC, Test & Measurement

Member Spotlight
Member Since: 02/23/13
Posts: 204
New in the Gallery:
SE cable question
Featured:

2017 NEC and Related
2017 NEC
Now Available!

Shout Box


Who's Online
0 registered (), 67 Guests and 10 Spiders online.
Key: Admin, Global Mod, Mod
 
New in the Gallery:
SE cable question
 
Top Posters (30 Days)
Admin 47
HotLine1 43
gfretwell 19
Ruben Rocha 12
Trumpy 9
 
Newest Members
KrmtFrg, Stack, Scotto, Freecrowder, clee512

ECN Electrical Forums - sponsored by Electrical Contractor Network - Electrical and Code Related Discussion for Electrical Contractors, Electricians, Inspectors, Instructors, Engineers and other related Professionals