The Electrical Contractor Network

ECN Electrical Forum
Discussion Forums for Electricians, Inspectors and Related Professionals

Books, Tools and Test Equipment for Electrical and Construction Trades

Featured:

2017 NEC and Related
2017 NEC
Now Available!

Recent Posts
Members: Did you know?
by Admin
37 minutes 25 seconds ago
Safety at heights?
by HotLine1
Yesterday at 08:51 PM
International Wire Colour Codes
by Texas_Ranger
Yesterday at 03:29 PM
Looking for older post
by Texas_Ranger
Yesterday at 03:22 PM
Last time to chat here
by Trumpy
01/20/17 11:41 PM
New in the Gallery:
Desk-mounted "power-board"
Shout Box

Top Posters (30 Days)
Admin 36
HotLine1 20
Ruben Rocha 17
gfretwell 16
Trumpy 15
Who's Online
1 registered (Admin), 81 Guests and 10 Spiders online.
Key: Admin, Global Mod, Mod
Topic Options
Rate This Topic
#101994 - 07/01/04 10:58 PM control wiring
frank Offline
Member
Registered: 05/29/01
Posts: 373
Loc: windsor ontario canada
Just saw bill woods post on control wiring.What about such applications as running a 24v control wire for a BMS like Metasys through 600v wireways and into combonation motor starters.Also what if the motor starter is fed from a seperatly derived system like an emergency generator.The metasys system uses an 8 pin relay to remotly start and stop air handlers via the auto function on the motor starter selector switch and current coils to prove that the unit is running.The relay and current coil are installed in the motor starer encosure.Insulation value for the control wiring is 600v


[This message has been edited by frank (edited 07-02-2004).]

[This message has been edited by frank (edited 07-02-2004).]
Top
2017 / 2014 NEC & Related Books and Study Guides


ECN Electrical Forums - sponsored by Electrical Contractor Network - Electrical and Code Related Discussion for Electrical Contractors, Electricians, Inspectors, Instructors, Engineers and other related Professionals