ECN Forum
Posted By: Admin Scary Control Enclosure - 02/22/03 04:37 AM
[Linked Image]
Quote
This is one of several pictures I took at a recycling center I had the misfortune of working at in 2001. Every panel in the place is like this (except for the ones I installed, of course). In this enclosure there is a quarter inch of liquid in the bottom, which might not be easily visible. The maintenance supervisor didn't think it was a big deal.

Jeff P.
Posted By: Bjarney Re: Scary Control Enclosure - 02/22/03 04:57 PM
OK if I go back to the plane and get two "distress bags"?
Posted By: Joe Tedesco Re: Scary Control Enclosure - 02/22/03 05:17 PM
Quote
The maintenance supervisor didn't think it was a big deal.

I am sure OSHA would make him a believer!

Unqualified Persons serving as Supervisor's .... This is a Classic Case here!!



[This message has been edited by Joe Tedesco (edited 02-22-2003).]
Posted By: SvenNYC Re: Scary Control Enclosure - 02/24/03 03:52 PM
Looking at it...some of the wires might be prone to getting pinched in the hinges when you close the cover -- especially the ones towards the bottom left hand corner of the box.

There also seem to be signs of damp. Look at the rust streaks in the lid - coming down from those black blocks. Some wire ties could also be a good idea....

Is it a good idea to leave so much slack in a panel like this?
© ECN Electrical Forums