Pictures submitted by Sierra Electrician :







Thanks Rob!.

{Message edited to fix up a few things.}


[This message has been edited by Trumpy (edited 11-25-2005).]

If upstream from the disconnect the water heater is protected by the proper ocpd (ie. the feeding panel or gear), then there's no problem...

On the otherhand, the deep P-Ring looks a bit suspect being nailed to the plywood.... Not to mention the grounding bar that appears to not-so-firmly be attached to the above can....

1. The W/H is protected by a 100A 3P breaker in the sub panel...the 100A 3P Fused disconect and (2) #4 THWN to the heater itself.

2. The 2" Plaster Ring is not intended for this use and is screwed to the plywood. This is a circuit for a bailer in a different area of the bldg.

These were found at an old Wal-Mart in Bakersfield,CA

Ahh Rob,
Now the penny has dropped, it was you that sent me the pics.
Just a little note to you guys that send us Mods pictures.
Could you please give your ECN Username as well, I don't know all of you guys' email addresses.
Hence the attributing the pics to Robert.
Not a big thing but it does save a bit of confusion.

But...Trumpy.. I thought we knew each other better than that.

Let me guess..... White Lane?

Calloway & Rosedale

It wil be a Smart & Final soon.

[This message has been edited by sierra electrician (edited 11-25-2005).]

Calloway & Rosedale?? You mean the old Save-Mart behind the Chevron? You're working literally about a mile from my house The closest Wal Mart (Rosedale & Coffee) was alive and kicking to ungodly proportions today

Randy

I was told it was a Wal Mart. my mistake

Sierra Electrician, I trust you are using the term "protected" loosely!