ECN Forum
Posted By: gserve 334.15(C) - 07/02/03 11:01 AM
In reference to 334.15(C) what is meant by "angles"? If I install a 4/O SER on the face or the studs in a straight line across the studs is this code compliant?
Posted By: DJF Re: 334.15(C) - 07/02/03 03:29 PM
I believe that normally 90^ & 270^ = Perpendicular, 0^ & 180^ = Parallel so these are not included in "angles".
Any derivation from the above would be the angles that are being addressed.
Posted By: dana1028 Re: 334.15(C) - 07/02/03 04:49 PM
anything not parallel to the framing members is an 'angle.' See the NECH - there is a color graphic showing the intent of this section.
© ECN Electrical Forums