ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat
Recent Posts
Increasing demand factors in residential
by gfretwell - 03/28/24 12:43 AM
Portable generator question
by Steve Miller - 03/19/24 08:50 PM
Do we need grounding?
by NORCAL - 03/19/24 05:11 PM
240V only in a home and NEC?
by dsk - 03/19/24 06:33 AM
Cordless Tools: The Obvious Question
by renosteinke - 03/14/24 08:05 PM
New in the Gallery:
This is a new one
This is a new one
by timmp, September 24
Few pics I found
Few pics I found
by timmp, August 15
Who's Online Now
0 members (), 260 guests, and 20 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Jul 2004
Posts: 5
F
fiddler Offline OP
Junior Member
In my neck of the woods there are some 240V

West German flouresent ballasts. ..pretty

small in size when compared to some former

English ballasts which lasted for upwards

of 8 years. These W G ballasts have a life

time of approx 3 years. Is there a way to

test these ballasts ? Thanks for any info.

Joined: Sep 2002
Posts: 1,498
Likes: 1
C
C-H Offline
Member
If they have a lifetime of 3 years, they have outlived themselves by a decade ;-)

Joined: Aug 2001
Posts: 7,520
P
Member
I'd say that 3 years is a very poor lifespan for a fluoro ballast. I find plenty of old fluorescent fittings in this area which are 30+ years old and still on their original ballast.

Admittedly though, the modern ones don't seem to have the longevity of the old types. [Linked Image]

You can check continuity with a regular ohmmeter, and use a megger to check for insulation faults. Testing for shorted turns requires more sophisticated equipment than that found in the average field electrical kit.

Joined: May 2004
Posts: 186
A
Member
Problem with the old balasts is that they probably cost more to run than the complete fitting on the newer versions.

Joined: Jul 2004
Posts: 200
U
Member
Agreed with the longevity issue on older ballasts. Took down some ancient 6' twin trough fittings last year in a big workshop; owner said they had been there since his grandfather owned the business. They were all working, bar a couple with lamp failures. JEEZ though...I could hardly lift the darn things! [Linked Image]

There were thirty-odd of them, all replaced with more up to date affairs; HSE said the lux level was too low for a workshop. The present owner has said that their electric bills are down but more likely coz of the halide replacements and the management system.


If hindsight were foresight, we'd all be millionaires!
Joined: Jul 2002
Posts: 8,443
Likes: 3
Member
Hold on a second, guys!
Just make sure that the tubes aren't of the 38mm RS (Quick-start) type.
And the fittings that supply these tubes, contain PCB's, usually in the Ballasts.
A fully sealed unit, but they have been known to leak Carcinogens(sp?)(Cancer-causing chemicals).
Watch out!!. [Linked Image]


Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5