Just saw bill woods post on control wiring.What about such applications as running a 24v control wire for a BMS like Metasys through 600v wireways and into combonation motor starters.Also what if the motor starter is fed from a seperatly derived system like an emergency generator.The metasys system uses an 8 pin relay to remotly start and stop air handlers via the auto function on the motor starter selector switch and current coils to prove that the unit is running.The relay and current coil are installed in the motor starer encosure.Insulation value for the control wiring is 600v
[This message has been edited by frank (edited 07-02-2004).]
[This message has been edited by frank (edited 07-02-2004).]
