ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat
Recent Posts
Increasing demand factors in residential
by gfretwell - 03/28/24 12:43 AM
Portable generator question
by Steve Miller - 03/19/24 08:50 PM
Do we need grounding?
by NORCAL - 03/19/24 05:11 PM
240V only in a home and NEC?
by dsk - 03/19/24 06:33 AM
Cordless Tools: The Obvious Question
by renosteinke - 03/14/24 08:05 PM
New in the Gallery:
This is a new one
This is a new one
by timmp, September 24
Few pics I found
Few pics I found
by timmp, August 15
Who's Online Now
1 members (Scott35), 260 guests, and 19 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Oct 2002
Posts: 1
D
Dandy Offline OP
Junior Member
I have a loft with the entrance door in one corner. The door will swing to the left covering the wall that the door is on. The perpendicular wall is 36" high which overlooks the Living room below.

My question is: is it Ok to put a double box on that short wall (for switches to control ceiling fan & recessed lighting respectively)?

I'd probably have to notch about 5 studs that make up the corner inorder to get wires to that spot. If Ok I'd probably mount the box as close as possible to the top of the 36" wall.

Locating the switch just outside the door doesn't seem like a very elegant solution, it would either be about 4 feet away from the door (because of bathroom door) or next to loft door but on a tall wall which is part of the L shaped staircase.

Any suggestions would be appreciated.

Dan

PS: Also can I locate duplex outlets along that same wall?

Joined: Apr 2002
Posts: 7,381
Likes: 7
Member
dandy:
1:Consult a copy of the NEC Code Book
2: Consult a "DIY" electrical book.
3: Apply for and obtain the required permit.
4: Think about calling a licensed electrician.

THe switch cannot be located on a wall that the door swings into.
There is no height restriction that I am aware of for switches, excluding ADA requirements.
The studs that you "notch" cannot be structurally damaged or weakened by the "notches"
You must install "nail plates" to protect the cables.
Locations for outlets fall into the 6'-12'rule "it's in the NEC".

When in doubt; hire a pro. Electricity is dangerous if installed in an inproper manner.

The above suggestions are "my humble opinion"
John


John

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5