|
1 members (Scott35),
381
guests, and
13
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
Joined: Jun 2005
Posts: 821
OP
Member
|
...does it say that meter pans shall be located on an outside wall and not in a basement in a single family dwelling?
|
|
|
|
Joined: Mar 2002
Posts: 125
Member
|
i think that is a local poco policyl. In the book I have says outside.
|
|
|
|
Joined: Jul 2004
Posts: 9,928 Likes: 34
Member
|
I see the real issue as being the amount of service conductor in the building before the disconnect. If this is a meter/disconnect assembly, installed at the "nearest the point of entrance of the service conductors" (per 230.70(A)(1)) I don't see an issue at all.
Greg Fretwell
|
|
|
|
Joined: Apr 2002
Posts: 7,381 Likes: 7
Member
|
Shock:
As said above, it's a POCO (PSE&G/JCP&L) requirement; not NEC
Years back, it was 'common' to install meters inside (basement/garage). IMHO, one of the reasons is efficiency in reading the meters; think of the time saved!
Now, readings by infrared remote, and over data lines, and wireless are becoming common.
PSE&G green book is the place for their specs, and First Energy (JCP&L) website for theirs.
John
John
|
|
|
|
Joined: Jun 2005
Posts: 821
OP
Member
|
Ok, thanks. I thought it was a POCO issue and I was right.
Thanks again for your input, John.
I know I ask alot of silly questions, but hey, if I don't ask them I'll never know, right?
|
|
|
|
Joined: Feb 2001
Posts: 308
Member
|
I have not heard the term 'meter pan' before, is that the term you meant to use or a spelling error? I have heard of meter cans. Just curious about the term use.
|
|
|
|
Joined: Apr 2002
Posts: 7,381 Likes: 7
Member
|
Steve: "Meter Pan" must be a 'Jersey Term', I've heard it since I've been in the trade. (35 yrs)
John
John
|
|
|
Posts: 70
Joined: January 2002
|
|
|
|
|