ECN Electrical Forum - Discussion Forums for Electricians, Inspectors and Related Professionals
ECN Shout Chat
ShoutChat
Recent Posts
UL 508A SPACING
by ale348 - 03/29/24 01:09 AM
Increasing demand factors in residential
by tortuga - 03/28/24 05:57 PM
Portable generator question
by Steve Miller - 03/19/24 08:50 PM
Do we need grounding?
by NORCAL - 03/19/24 05:11 PM
240V only in a home and NEC?
by dsk - 03/19/24 06:33 AM
New in the Gallery:
This is a new one
This is a new one
by timmp, September 24
Few pics I found
Few pics I found
by timmp, August 15
Who's Online Now
1 members (ale348), 302 guests, and 14 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Rate Thread
#25924 05/23/03 08:49 AM
Joined: Nov 2002
Posts: 9
M
Junior Member
I am going to Korea to install some machinery and I am wondering if they have any codes over there? I will be installing then according to the NEC because I can't go wrong with that but... you never know!

#25925 05/23/03 09:15 AM
Joined: Sep 2002
Posts: 1,498
Likes: 1
C
C-H Offline
Member
Quote

I am going to Korea to install some machinery and I am wondering if they have any codes over there?

All industrialised countries have codes.

Quote

I will be installing then according to the NEC because I can't go wrong with that but... you never know!

The bad news is that you can go very wrong with the NEC. If you don't believe me, I'm sure there are half a dozen people here who can back me up. The good news is that you were wise enough to ask.

You will have to check what the Korean code says and also who is allowed to install what. The fact that you intend to follow the NEC indicates that this is an electrical installation rather than just an installation of a machine. I is likely that only Korean electricians are allowed to carry out electrical work in Korea without supervision.

{Don't take this like I'm telling you off, I only want to warn you.}

#25926 05/23/03 09:30 AM
Joined: Nov 2002
Posts: 9
M
Junior Member
And where can you find anything about eletrical codes in Korea??? And yes the machinery is electrical. It's 2-3000 amp rectifiers and 1-6000 amp for electro-polishing. I have installed them here in California but not over there. Thanks for the comments but still not the aswer.

#25927 05/23/03 10:17 AM
Joined: Sep 2002
Posts: 1,498
Likes: 1
C
C-H Offline
Member
I've been unable to find the name of the electrical code. But the people at Korea electrical safety corporation should know.

Have you checked that you don't need to certify your product?
http://scs.ktl.re.kr/

The Korean equivalent to UL, except that it appears to be mandatory.


Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5