ECN Forum Forums Photo Discussion Forums Violation Photo Forum Let's Be Reminded About This Situation!

The article was in the EDI magazine


[This message has been edited by Joe Tedesco (edited 12-27-2004).]

Joe,
Good job! That is the case that I was thinking about. Thanks.
Don

I just want to point out two items from the article:


It's easy to "Monday-morning quarterback." That said, what if a permit was pulled? Can sloppy workmanship contribute to a dangerous situation? The whole situation is a shame for all parties involved.

"edi"? Doesn't seem like it's been 12 years already.

Hey! That's the story Don & I were thinking of!

I remembered it pretty well...

The first time I read this story years ago, I was apprehensive of which side to be on.
I've seen so much bad work that I could only hope for such enforcement.

However, as I gained experience, I realized that under just the right circumstaces,
I could have made the same mistakes. Perhaps the home-owner had supplied the replacement
and the electrician merely overlooked checking the nameplate rating,
subconsciously trusting his customer to have purchased the right thing... Perhaps it was a long day,
and he was in a rush trying to fit these people into his schedule.
There was no mention if an EGC was even available, only that the ground screw had not been used. (Lawyers can be tricky!)

A really sad situation all around.



[This message has been edited by sparky66wv (edited 01-02-2003).]

As I see it, the electrician's ability to pass the journeyman's test suggests that he knew what he was doing was wrong, but just didn't care. Sounds like negligence to me!
Moreover, isn't it the stated purpose of contractor licensing to protect the public from incompetent or reckless work?
I say, let him work under supervision- if anyone would hire him!