I have a 460' run of 5'' Sched 40. 2 90 deg bends. One on each end. I had string in the pipe. Had used air compressor w/4'' emt mouse and it sailed right through.
Now, a couple mos later when I am going to pull wire, my help doesnt show up. I tied mt pulling rope to the end of the string and started pulling fromt the other end. Well, I pulled my tail through. Rope was too short, which I had known, I was going to tie another rope onto it, but, too late.
Now I cannot get mouse through. Used compressor again to no avail. Just bunching up the string. Used full bucket already. ANY ADVISE APPRECIATED!!