ECN Forum Forums General Topics of the Trade General Discussion Area How do you bend EMT offsets?

There's the push conduit into corner, mark, flip conduit around and bend on the star method for small sizes where you're going into an inside corner. The EMT stays up a lot better than a tape measure.


BTW-- It's been a while since we've brought this up, but if you want your computer to put in a ° sign, just hold down the "alt" button on your keyboard, and type 0176. Now, let up on alt button. Should be a °.

Try alt with 0216 and you'll get a Ø.
Easier than writing degrees or phase.