Lighting A Tunnel
*** MODERATOR'S NOTE: ***Topic Posted + Image Uploaded By Scott35 For ECNThis discussion may be found in the General Discussion Forum, under the topic:
Lighting A Tunnel? Text copied / pasted from relavent thread:
ok here is the deal i have a extra credit project due fo res. wiring class. and i am LOST. i need to hook up 6 switches with 6
lights, there can be only two lights on at a time when u turn on one switch it turns on the light in front and turns off the
one in back off but leaves the light right above it on, like lights in a long tunnel. i can use any combination of the
following single pole/double pole/three-way/four-way.
i kinda know u have to have three-ways at each end but after that i am very lost. any help would be greatly appreciated, thanks
in advance
------------------------------------------------------
Relative Schematic Image Below
------------------------------------------------------
*** Please Note: ***
I am unsure who sent the original AutoCAD version of this Schematic to me, as it was sent via E-mail quite a while back.
I appologize for the delay. The file got "Lost" on my network, and just recently found (found it today!).
Since I am uploading several other posts today, figured this would be a good time to upload the "Tunnel Lighting" drawing too.
When this drawing was first sent to me, I did not have a compatible AutoCAD version to open the file.
Now a more current version of AutoCAD exists on my machine! (right now, it's AutoCAD 2000, but there is speculation of a nice
full version of AutoCAD 2005 showing up here very soon!)
--end
Scott35
new 07.05.2006 @ 22:17:00
path = X:\elect_eng\ecn_users\upload_items\*.*