Stamcon,
Yeah, mate, that's the stuff, I never new they treated it with Boric Acid.
It says that this is used for fire resistance, I beg to differ, with this.
The Fire Safety division, of the Fire service over here, ran some tests on this stuff, about a year ago, they concluded that it was rather hard to extinguish if it did ignite and it did not take a flame to cause ignition, either, just conducted heat from an overloaded transformer, was enough.
I personally would use only Fibre-glass Batts,these have a lot higher Ignition temperature.
C-H,
I remember working next door, to a house, where some of that foam insulation was being installed, long story short, I'm not sure if the guy mucked up the injection pressure,
but, man, this stuff was oozing out all over the place and fast too, it was funny to watch. [Linked Image]